|

What will I learn from this course?
Instruction is designed so technical personnel responsible for the hands-
on maintenance of the LM6000 will benefit most from this training.
Scope of training focuses on selected Level 2 procedures identified in the
applicable Operation and Maintenance manual.
Who should attend?
Owners, operators and customer personnel concerned with the day-to-day operations and maintenance of the GE LM6000 aeroderivative gas turbine.
Prerequisites
A basic understanding of your gas turbine or completion of the LM6000 Familiarization course is highly recommended, as well as a reasonable level of mechanical skill and use of hand tools is required. Instruction is given in English; therefore, a reasonable ability to read and understand spoken English is required.
Duration
7 days
Agenda
| Day 1-2 |
Introduction |
| |
Course overview /content |
| Course schedule |
| Training Manual review |
| Removal Variable Inlet Guide Vane |
| Day 3 |
Stage 0 Blades Replacement |
| |
Removal Low Pressure Compressor Module |
| Replacement No. 1 Air / Oil Seal |
| Day 4 |
Low Pressure Compressor Stage 1-3 Blades Replacement |
| |
Low Pressure Compressor Stage 0-3 Vanes Replacement |
| Installation Low Pressure Compressor Module |
| Day 5 |
Removal High Pressure Compressor Upper Case |
| |
High Pressure Compressor Stage Blades Replacement |
| Day 6 |
High Pressure Compressor Stage Vanes Replacement |
| Day 7 |
Installation High Pressure Compressor Upper Case |
The following training dates are available in 2009:
|